Smartek-systems SAS-1 Relay Interface Configuration And Connection Manual de usuario

SSSSSmarTek Systems, Inc.SmarTek Systems, Inc.14710 Kogan DriveWoodbridge, VA 22193 703-680-6554 Sales 410-315-9727TMTMSensing and System Integration

SmarTek Systems (www.smarteksys.com)2(This Page Intentionally Left Blank)

SmarTek Systems (www.smarteksys.com)3SAS Relay Interface Configuration and ConnectionMany traffic monitoring sites in place (orplanned) and traffic co

SmarTek Systems (www.smarteksys.com)4Connecting and Routing Relay Signals For The SAS-RI Type 170 CardThe type 170 card version is comprised of aSAS-R

SmarTek Systems (www.smarteksys.com)5a card edge contact (F, W, S, Y). From Figure 4 it can be seen that the SAS-RI Main card routesrelay signals 1A,

SmarTek Systems (www.smarteksys.com)6should light based on detections by the SAS-1. To setup SAS-1 or to repeat the SAS-1 setupusing the SAS Monitor

SmarTek Systems (www.smarteksys.com)7on the second SAS-RI to the RJA jack on the third SAS-RI. This pattern continues for up to 6SAS-RI cards.Note: E

SmarTek Systems (www.smarteksys.com)8Note: Each SAS-RI used as slaves (SAS0002 thru SAS0006) in Figure 7 must be factorymodified for receive only capa